Re: Roll Repair Table
By Terry Smythe
John, yes, you are correct that I overlap repair tape and slice off the excess with a steel rule and X-Acto knife. I agree that care has to be taken not to overdo it. A shortcoming does emerge from this process in that the base board becomes progressively damaged from the knife edge cuts and needs to be replaced. I'm wondering if anyone has found a more durable cutting surface that can better withstand repeated cuts from the X-Acto knife.
Any chance that photos of your roll repair device might be made available as an on-line graphic? If you don't have access to a scanner, perhaps you can mail photos to me and I'll scan them for all.
Regards, Terry
Terry Smythe smythe@mts.net
55 Rowand Avenue smythe@freenet.mb.ca
Winnipeg, MB, Canada R3J 2N6 (204) 832-3982 (voice/fax)
http://www.winnipeg.freenet.mb.ca/~smythe
|
(Message sent Thu 19 Dec 1996, 13:41:28 GMT, from time zone GMT-0500.) |
|
|
Mechanical
Music Digest™ Archives
